Mitsubishi MELSEC-Q Series User Manual page 265

6 FUNCTIONS
Item
Time/Interval
Mail setting for event
occurrence
Save
Back / Cancel
Select time/interval event
setting No. and click on
Load
6 - 63
[Setting Item]
Sets the monitoring time/interval.
Makes setting when sending e-mail at event occurrence.
Saves the setting.
The settings are updated when the "Update" button on the Setting update screen is clicked,
the programmable controller is powered off and then on, or the CPU module is reset.
Discards the changed setting and returns to the time/interval event setting screen.
Loads the parameters of the No. selected in time/interval event setting No. and displays them
on the Edit screen.
(a) Time/interval
For the timing at which an event occurs, select either of the following.
1) Time specification
• An event occurs at the specified time.
Hour
Minute : 0 to 59, "Per" (Per minute can be specified only when Per
Second : 0 to 59
• An event does not occur when the Web server module is started.
2) Interval specification
An event occurs once when the Web server module is started or when
the setting is updated, and thereafter at the specified interval. (1 to
86400 seconds)
(b) Send an e-mail when an event occurs.
1) Set whether e-mail will be sent upon event occurrence or not.
2) Refer to Section 6.6.6 for e-mail transmission by the event monitor
function.
(c) Disconnect from the network after sending mail.
Disable this setting when it is not desired to disconnect the network after
sending e-mail at event occurrence.
This setting is available when the Web server module is not continuously
connected to the network.
Refer to Section 5.4 for the procedures for connecting to and disconnecting
from the network for non-continuous connection.
(d) E-mail main text
1) Enter the main text of e-mail.
(0 to 256 characters)
2) Refer to Appendix 4 (5) for the characters applicable to the e-mail
main text.
Description
: 0 to 23, "Per"
hour is specified)
MELSEC-Q
6 - 63