Mitsubishi MELSEC-Q Series User Manual page 171

4 SET-UP AND PROCEDURE BEFORE OPERATION
Removal/Replacement of Compact Flash
Stop file access and disable read from/write to
Compact Flash
Remove Compact Flash
(Refer to Section (4))
Insert a new Compact Flash
(Refer to Section (3))
Cancel file access stop and enable read from/write to
Compact Flash
4 - 54
[Removing or Replacing the Compact Flash
Before removing or replacing the Compact Flash
access by the following procedures.
Is power ON?
YES
card. (Refer to Section (1))
TM
card.
TM
Replace?
YES
card.
TM
Restart?
YES
card. (Refer to Section (2))
TM
Completed
Important
Failure to observe the above procedure may cause erasure of logging data during
processing, corruption of data in the Compact Flash
system fault.
For a Compact Flash
(1) Stopping file access
(a) Stop a file access.
1) Turn File access stop request (Y2) from OFF to ON.
(b) Confirm that file access has stopped.
1) Compact Flash
2) File access status (X2) is ON.
3) Turn File access stop request (Y2) from ON to OFF.
TM
card
TM
NO
Turn programmable controller ON.
NO
NO
Turn programmable controller OFF.
TM
card fault, refer to Section 9.1 (9).
TM
card setting status (X1) is OFF.
Card]
TM
card, be sure to stop the file
TM
card during access, or a file
MELSEC-Q
4 - 54