Mitsubishi MELSEC-Q Series User Manual page 197

5 CONNECTING WEB SERVER MODULE TO NETWORK
5 - 16
(b) Disconnection using line disconnection part
When a button is clicked in a line disconnection part, the Web server
module disconnects from the network. (Refer to Section 7.4.3.)
(c) Disconnection using Disconnect function (Only when modem is connected)
When the "Disconnect function" is enabled in the dial-up setting, the Web
server module automatically disconnects from the network if no access is
made to the Web server module for the specified period of time. (Refer to
Section 4.6.4.)
(d) Automatic disconnection after completion of dedicated instruction
(WMSEND, FTPPUT, FTPGET)
When the Web server module has automatically connected to the network
at execution of the dedicated instruction, it automatically disconnects from
the network after the dedicated instruction is completed. (Refer to Chapter
8.)
(e) Automatic disconnection after e-mail transmission or file transfer by logging
function
When the Web server module has automatically connected to the network
at e-mail transmission or file transfer, it automatically disconnects from the
network after e-mail transmission or file transfer. (Refer to Section 6.4.)
(f) Automatic disconnection after e-mail transmission by event function
When the Web server module has automatically connected to the network
at e-mail transmission with "Disconnect from the network after sending
mail." enabled in the event setting, the Web server module automatically
disconnects from the network after e-mail transmission. (Refer to Section
6.5.)
When "Disconnect from the network after sending mail." was disabled in
the event setting, the Web server module does not disconnect from the
network after e-mail transmission.
POINT
(1) Before the Web server module is disconnected from the network, a measure
for the next network connection should have been taken.
(2) When the Web server module has automatically connected to the network at
execution of any of the following operations, it automatically disconnects from
the network after completion of the corresponding operation.
However, if any of these is executed with the Web server module connected to
the network (Network connection status (X4) is ON), the Web server module
does not disconnect from the network after completion of the operation.
Execution of dedicated instruction (WMSEND, FTPPUT, FTPGET)
E-mail transmission/file transfer by logging function
E-mail transmission by event function
MELSEC-Q
5 - 16