Installing The Driven Deflector; Removing The Driveline Deflector - MacDon R85 Operator's Manual

Installing the Driven Deflector
Follow these steps to replace the driven rotary deflector:
1. Position new deflector (C) on spindle so that it clears
accelerators (D).
2. Install cover (B) and secure with four bolts (A).
3. Tighten bolts.
4. Remove block of wood (if used).
WARNING
Ensure cutterbar is completely clear of foreign
objects. These objects can be ejected with
considerable force when the machine is started and
may result in serious injury or machine damage.
Removing the Driveline Deflector
Follow these steps to replace the driveline deflector:
1. Lower the header fully.
2. Shut down the engine and remove the key.
3. Open cutterbar doors. Refer to
page 28.
4. Locate the deflector (C) with the driveline in the center
of it.
5. Remove the four bolts (A) that secure the driveline (B)
and disc to the spindle.
6. Rotate the deflector (C) as required so that large
opening in deflector faces you.
7. Remove the driveline (B) through the larger opening in
the deflector.
8. Remove spacer plate (D).
169455
MAINTENANCE AND SERVICING
5.5 Cutterbar Doors,
138
Figure 7.48: Driven Deflector
Figure 7.49: Driveline Deflector
Revision F