Installing The Driven Deflector; Removing The Driveline Deflector - MacDon R85 Operator's Manual

4. Remove four bolts (A).
5. Remove cover (B) and deflector (C).
Installing the Driven Deflector
Follow these steps to replace the driven rotary deflector:
1. Position new deflector (C) on spindle so that it clears
accelerators (D).
2. Install cover (B) and secure with four bolts (A).
3. Tighten bolts.
4. Remove block of wood (if used).
Removing the Driveline Deflector
Follow these steps to replace the driveline deflector:
1. Lower header to ground.
2. Shut off the engine and remove the key.
3. Open cutterbar doors.
Doors, page 31.
169457
MAINTENANCE AND SERVICING
See Section 5.5 Cutterbar
Figure 7.38
Figure 7.39
138
Rev. F