Replacing The Separator Roller - Kodak Ngenuity 9090DB User Manual

5-14

Replacing the separator roller

8. Pull the separator roller door forward and hold it in place while you
remove the separator roller by lifting it off the cradle.
9. Remove the roller from the rest of the assembly as shown.
10. Reassemble the components using a new roller, duplicating the
assembly.
11. Open and hold the separator roller door to reinstall the separator
roller. Align the separator roller correctly with the slots. Align the flat
end of the shaft with the slot in the cradle and gently seat the shaft,
which should fall in place. Do not apply pressure to seat the shaft
12. Gently release the separator roller door back in place. Verify that
the separator roller is seated level.
13. Close the transport cover.
14. When all four tires on the skimmer rollers and the separator roller
have been replaced, reset the maintenance reminder by clicking on
the Replace Feed Rollers hyperlink on the Maintenance monitor.
15. Click Yes on the dialog box to confirm the tires/rollers have been
replaced. The reminder will be reset for the next required
maintenance session.
.
A-61662 April 2010