Table of Contents
Advertisement
Replacement
procedures
Replacing the feed module
or feed module tires
Releasing the feed module
60
This section provides procedures for replacing the following parts. Use the list
below as a guideline for frequency of replacement.
IMPORTANT:Power down the scanner before opening the scanner to
replace parts.
•
Feed module tires and separation roller tires — tire life will vary
depending upon paper types, environment and cleanliness. Nominal tire
life is approximately 500,000 documents; results will vary. Degradation of
feeder performance, multiple feeds, stoppages, etc. indicate a need to
change tires. Change all of the tires on the feed module and separation
roller at the same time.
•
Feed module and separation roller — it is recommended that you install
a new feed module and separation roller every 4th tire change. Install a
new feed module and separation roller at the same time.
•
Pre-separation pad — it is recommended that you change the pre-
separation pad at least as often as you change the feed module/separation
roller tires.
•
Imaging guides — replace when the imaging guides are heavily
scratched and defects show in the image.
There are two methods of releasing the feed module.
Method 1:
•
Press the release tab to the right to release the feed module from the
scanner.
A-61837 September 2016
Advertisement
Table of Contents
