Scan Settings Screen - Kodak PS50 Series User Manual

Scan Settings screen

3-10
The Scan Settings screen allows you to change the default settings (as
shown) that are used in the scanning process.
Scan as — select either Color or Grayscale.
NOTE: Color scanning is recommended for most photos, including
black and white and grayscale photos, so KODAK Perfect
Touch and Sharpen processing may be applied to the scanned
images. Use Grayscale scanning for exception processing if
color scan results are not what you desired.
Batch Scan Mode — select one of the following batch scan modes:
• Front Side — captures the front side of the photo that is in the input
tray. This is the recommended mode for photos.
• Back Side — captures the back side of the photo that is in the input
tray.
• Two Sided — captures both sides of the photo as two separate
image files labeled A and B.
NOTE: Photos should always be scanned face up, with the tops
pointing down into the scanner.
Transport Timeout — allows you to set the amount of time the scanner
will wait after the last photo enters the transport before the transport
timeout action is taken. You can specify a time delay setting from 1 to
20 seconds to allow more time to insert the next photo or document into
the current batch.
Flatbed Scan Mode — this option is only visible if you have the Kodak
Photo Selector Accessory.
• Enable Photo Selector — check this option to enable the Photo
Selector Accessory. For more information, see the section entitled,
"Photo Selector screen" earlier in this chapter.
A-61760 September 2012