Detaching R216 Rotary Disc Header - MacDon M1 Series Unloading And Assembly Instructions

7. Pull platform (A) towards the cab until it stops and the latch
is engaged.
DANGER
Ensure that all bystanders have cleared the area.
8. Start the windrower engine.
9. Extend center-link (A) fully. Ensure that there is some slack
in harness (B).
10. Retract center-link (A) fully. Ensure that there is not an
excessive amount of harness (B) hanging down.
11. Turn off the windrower engine, and remove the key.
12. Adjust harness (B) as needed.
13. Tighten all the cables along the harness.
14. If necessary, calibrate both the knife drive and header position sensors on the windrower. Calibrate both the knife
drive and header position sensors whenever you are:
• Attaching the header to the windrower for the first time
• Changing the speed sensor or hydraulic drive motor on the header
• Changing the header drive pump associated with the knife drive, Harvest Performance Tracker (HPT), or the master
controller on the windrower
For instructions, refer to
Calibrating Header Position Sensors on Harvest Performance Tracker Display, page

5.5.5 Detaching R216 Rotary Disc Header

Detach the header when replacing the header with a different one or when storing the header.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat for any reason.
DANGER
Ensure that all bystanders have cleared the area.
215620
ATTACHING A HEADER TO THE WINDROWER
5.7.1 Calibrating Knife Drive on Harvest Performance Tracker Display, page 230
Figure 5.228: Left Cab-Forward Platform
Figure 5.229: Electrical Connection
220
and
233.
5.7.2
Revision A