MacDon M1 Series Unloading And Assembly Instructions page 97

Installing rear light assembly – no ballast package required
1. Remove eight bolts and washers from the rear light
assembly and separate bezel (A) from left and right light
supports (B).
2. Remove nuts (C) from light supports (B). Retain the
hardware for installation.
3. Remove two bolts (A), cover (B), and seal (C) from behind
each light support.
4. Align connector (A) and plug the engine-forward headlight
harness into headlight (B) as follows:
• Harness P214 to the right engine-forward headlight
• Harness P213 to the left engine-forward headlight
215620
ASSEMBLING WINDROWER
Figure 3.87: Rear Light Bezel Assembly
Figure 3.88: Light Supports
Figure 3.89: Right Light Support
85
Revision A