MacDon M1 Series Unloading And Assembly Instructions page 98

5. Install seal (A) onto tail/brake light harness (B) and feed the
harness through the access hole. Seat the seal into the
access hole. Make the following electrical connections:
• Harness P210 to the right tail/brake light
• Harness P215 to the left tail/brake light
6. Replace cover (C) and secure it with bolts (D).
7. Press headlight harness (E) into clip (F) on the light support.
8. Repeat on opposite side.
9. Mount light support (A) to stud (B) on rear pivot support
with existing nut (C). Repeat on opposite side.
10. Plug tail/brake light harnesses (A) into lights (B) on bezel
assembly.
215620
ASSEMBLING WINDROWER
Figure 3.90: Right Light Support
Figure 3.91: Left Light Support
Figure 3.92: Right Tail/Brake Light
86
Revision A