MacDon M1 Series Unloading And Assembly Instructions page 99

11. Use eight bolts and washers (A) to attach rear light
bezel (B) to light supports.
Installing rear light assembly – ballast required
1. Refer to Table 3.2, page 84
2. Shut down the engine, and remove the key from the ignition.
3. Separate light bezel assembly (A) by removing six hex
screws (B).
4. Retain center portion (A) of the light bezel assembly for
reinstallation. Install six hex screws (B) on the side bezels.
NOTE:
These hex screws will be used when reinstalling the center
portion of light bezel.
215620
ASSEMBLING WINDROWER
to determine the amount of ballast to add to the windrower.
Figure 3.93: Rear Light Bezel Assembly
Figure 3.94: Bezel Assembly Removed from
Windrower
Figure 3.95: Bezel Assembly Separated
87
Revision A