Connecting D1X Or D1Xl Series Draper Header Hydraulics - MacDon M1 Series Unloading And Assembly Instructions

24. Turn scroll knob (A) to highlight left (B) or right (C) float and
press knob (A) to activate the selection.
25. Rotate scroll knob (A) to adjust the float setting and press
the knob to confirm your selection.
IMPORTANT:
Float adjustments of 1.0 (out of 10) change the header
weight at the cutterbar by approximately 91 kg (200 lb.).
Adjust the float in increments of 0.05 to fine-tune the
header's performance.
26. Shut down the engine, and remove the key from
the ignition.
27. Grasp one end of the draper header and lift. The lifting
force should be 357 N (80 lbf.) and should be the same at
both ends.
28. Proceed to 5.2.3 Connecting D1X or D1XL Series Draper
Header Hydraulics, page

5.2.3 Connecting D1X or D1XL Series Draper Header Hydraulics

Connecting the header's hydraulics to the windrower is a simple procedure, thanks to the hydraulic hose management
system. There is an additional step to perform if you are switching from using a rotary header to using a draper header.
IMPORTANT:
To prevent contamination of the hydraulic system, use a clean rag to remove dirt and moisture from all hydraulic couplers.
1. Push the link on latch (C) and pull handle (A) on hydraulic
hose management system (B) rearward to disengage the
arm from the latch.
2. Move hydraulic hose management system (B) toward the
left cab-forward side of the windrower.
215620
ATTACHING A HEADER TO THE WINDROWER
152.
Figure 5.57: HPT Display
Figure 5.58: Hydraulic Hose Management System
152
Revision A