Table of Contents
Advertisement
19.2.4
1.888.610.7664
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Click or tap the input field of File Name to input the file name to be saved with
the pop-up virtual keypad.
•
Set the file path
Click or tap the input field of File Path, then the disk management interface is
displayed. Select the target file path and then click or tap OK. For detailed
operations, refer to descriptions in
When a USB device is not connected, the default file path is the "Local Disk";
when a USB device is detected, the path is automatically set to "D:".
•
Overlay
Click or tap the Overlay on/off switch to enable or disable the overwriting
function. When this function is enabled, the existing file in the specified file path
will be overwritten by the newly saved file that has the same filename as the
existing one.
Click or tap Save, the current setup file is saved based on the settings and the storage
menu is disabled.
TIP
When the quick action function is set to "Save Setup" or "Save Group" with "Save Setup"
selected, you can press the front-panel
Binary Data Format (.bin)
Binary data format stores waveform data in binary format and provides data headers
that describe these data. As data are displayed in binary format, its file size is much
more smaller than that in ASCII format. If several channels are enabled, then all the
displayed channels will be saved (save the first channel then save the second, and
then it goes on like this until all the displayed channels are saved).
Table 19.1 BIN File Format
File
Waveform
Header
Header
16 Bytes
140 Bytes
In BIN file format, it contains the following channel data:
•
CH1 Data
•
CH2 Data
•
CH3 Data
•
CH4 Data
www.calcert.com
15
10
20
5
25
0
30
Disk Management
key to save the setup.
Waveform
Channel
Data
Data
Header
16 Bytes
n Bytes
Store and Load
.
Waveform
Waveform
Header
Data
Header
140 Bytes
16 Bytes
sales@calcert.com
DHO1000 User Guide
Channel
Data
n Bytes
Advertisement
Table of Contents
