Reset To Factory - Proxim ORiNOCO AP-8000 User Manual

Using Web Interface to Manage the Access Point
2. Select the Access Table Status checkbox. This will enable the Management Access Control.
NOTE: The Add button is displayed, only when the Access Table Status is enabled.
3. Click Add to make a new entry. The Management Access Table Add Row page appears.
4. Enter the IP Address of the device.
5. Select the Entry Status.
6. Click Add.
7. Click REBOOT to apply the changes to the AP device.

Reset to Factory

Resetting the AP to its factory defaults will remove the configuration file and reboots the AP device automatically.
To Reset the Factory defaults,
1. Navigate to Management > Reset To Factory. The following page appears.
2. Click Ok to reset factory settings else click Cancel.
Figure 6-48 Management Access Control Page
Figure 6-49 Management Access Control - Add Row Page
Figure 6-50 Reset to Factory
AP-8000 User Guide
92