Ethernet - Proxim ORiNOCO AP-8000 User Manual

Using Web Interface to Manage the Access Point
2. Configure the following parameters:
• 11n AMPDU Status: Set this to "Enable".
• AMPDU Max Num Frames: Enter a value. It represents the maximum number of AMPDU frames that can be
transmitted. It can be configured up to 64 frames.
• AMPDU Max FrameSize: Enter a value for the AMPDU frame size that can be transmitted. It is defined in bytes. It
can be configured up to 65535.
• 11n AMSDU Status: Enable this feature. When you enable this feature, the device does aggregation at link layer
which helps to increase the throughput. The entire AMSDU frame is considered as one MPDU. It supports two
values:
— 4K or 4096
— 8K or 8192
NOTE: Currently, our devices do not support AMSDU on the transmit side. The Access Point can receive only 4K
length of AMSDU.
• Frequency Extension: Select the frequency extension for the wireless interface.
• Guard Interval: Select the Guard Interval. The supported values are: 400 nSec and 800 nSec. By default, the
value is set to 400nsec.
• Tx Antennas and Rx Antennas: Select the Tx Antennas and Rx Antennas' value.
3. Click Ok.
NOTE: Follow the above mentioned steps to configure the 11n Properties feature for Interface 2.

Ethernet

To configure Ethernet Port parameters,
1. Navigate to Configuration > Ethernet. The Ethernet Interface Properties page appears.
Figure 6-11 11n Properties Page
AP-8000 User Guide
67