Ip Configuration - Proxim ORiNOCO AP-8000 User Manual

Using Web Interface to Manage the Access Point
• EDCA Profile Name: Enter the EDCA Profile Name that you have defined in the EDCA Table.
• QoS NO ACK Status: Select the QoS acknowledgement status for the QoS Profile table.
3. Click Ok.
QoS Policy
To configure QoS Policy parameters,
1. Navigate to Configuration > QoS > QoS Policy. The Qos Policy page appears.
2. Configure the following parameters.
• Policy Name: By default, the Policy Name is displayed.
• Policy Type: By default, the Policy Type is displayed. The available Policy types are:
– Inbound Layer 2: Inbound traffic direction, Layer 2 traffic type
– Outbound Layer 2: Outbound traffic direction, Layer 2 traffic type
– Inbound Layer 3: Inbound traffic direction, Layer 3 traffic type
– Outbound Layer 3: Outbound traffic direction, Layer 3 traffic type
• Priority Mapping: Enter the Priority Mapping. For layer 2 policies, an index from the 802.1D to 802.1p mapping
table should be specified. For layer 3 policies, an index from the 802.1D to IP DSCP mapping table should be
specified.
• QoS Marking Status: Select the QoS Marking Status.
• Entry Status: Select the Entry Status.
NOTE: If you want to customize a particular Policy Type, then the Entry Status for that Policy Type should be
Enabled.
3. Click OK.

IP Configuration

To configure the internet (TCP/IP) settings for the Access Point,
1. Navigate to Configuration > IP Configuration. The Network IP Configuration page appears.
Figure 6-26 QoS Policy page
AP-8000 User Guide
76