Vlan - Proxim ORiNOCO AP-8000 User Manual

Using Web Interface to Manage the Access Point
2. Address Type: Select the Address Type as either Static or Dynamic.
– If you select the Address Type as Static, then you need to configure the following parameters and click OK:
— IP Address
— Subnet Mask
— Gateway IP Address
– If you select the Address Type as Dynamic, then the following parameters will remain as read only:
— IP Address
— Subnet Mask
— Gateway IP Address
3. Click Ok.
NOTE: You must reboot AP to affect the change in IP Address configuration.

VLAN

VLANs segment network traffic into workgroups, which enable you to limit broadcast and multicast traffic. Workgroups
enable clients from different VLANs to access different resources using the same network infrastructure. Clients using the
same physical network are limited to those resources available to their workgroup.
The AP can segment users into a maximum of 4 different workgroups per radio. Therefore there are a total of 8 different
workgroups/VLANs for dual radio.
To configure VLAN,
1. Navigate to Configuration > VLAN. The VLAN page appears.
Figure 6-27 Network IP Config
Figure 6-28 VLAN Page
AP-8000 User Guide
77