Snmp Read, Read-Write Password And Trap Host Table Configuration; System Information Configuration - Proxim ORiNOCO AP-8000 User Manual

Using CLI to Manage the Access Point
(config-mgmt-tftp)#exit
(config-mgmt)#exit
(config)#exit
Show command:
Given below are the default TFTP configuration.
System Name# show management tftp
// RUNNING-CONFIGURATION //
// TFTP Configuration //
tftp {
server-ip: 169.254.128.133
file-name: image.bin
file-type: image
operation-type: none
operational-status: idle
}

SNMP Read, Read-Write Password and Trap Host Table Configuration

To change SNMP passwords, use the following commands.
# configure
(config)# dev-management
(config-mgmt)# snmp
(config-mgmt-snmp)# read-write-password public
(config-mgmt-snmp)# read-password 123456
(config-mgmt-snmp)# trap-host-table
(config-mgmt-snmp-trap<tble>)# index 1 ipaddress 192.168.1.1
Show command:
System Name# show management snmp trap-host-table
// RUNNING-CONFIGURATION //
// SNMP Trap Host Table //
index 1 {
ip-address: 192.168.1.1
password: ******
}

System Information Configuration

To configure System Information, use the following commands.
# configure
(config)# dev-management
(config-mgmt)# system
(config-mgmt-sys)# system-information
(config-mgmt-sys-sysinfo)# ?
Possible completions:
Email
exit
gps-altitude
System Contact Email
Exit from configure mode
System GPS Altitude
AP-8000 User Guide
140