System Management Configuration - Proxim ORiNOCO AP-8000 User Manual

Using CLI to Manage the Access Point
gps-latitude
gps-longitude
location
phone-number
system-name
(config-mgmt-sys-sysinfo)# email name@Organization.com
(config-mgmt-sys-sysinfo)# system-name System-Name
(config-mgmt-sys-sysinfo)# phone-number 1234567890
(config-mgmt-sys-sysinfo)# location systemlocation
(config-mgmt-sys-sysinfo)# gps-altitude -121.8893
(config-mgmt-sys-sysinfo)# gps-latitude 37.3321
(config-mgmt-sys-sysinfo)# gps-longitude -121.8893
(config-mgmt-sys-sysinfo)#exit
(config-mgmt-sys)# exit
(config-mgmt)# exit
(config)# exit
Show command:
System Name# show management system information
// RUNNING-CONFIGURATION //
// System Information Configuration //
system {
description: System Description
country-code: BE
OID: 1.3.6.1.4.1.841
uptime: 0-02:09:24.39
name: System Name
contact-mail: name@Organization.com
phone-number: Contact Phone Number
location-name:
gps-longitude: -121.8893
gps-latitude: 37.3321
gps-altitude: 10
productdescr:
}

System Management Configuration

To configure System Management parameters, use the following commands.
(config-mgmt)#system
(config-mgmt-sys)# management
(config-mgmt-sys-sysmgmt)# ?
Possible completions:
exit
factory-reset
restore
NOTE: Use the below command to reset device to factory defaults. Note that device will restart automatically once the
reset operation is completed.
(config-mgmt-sys-sysmgmt)# factory-reset 1
System GPS Latitude
System GPS Longitude
System Location
System Contact Phone Number
System Name Configuration
System Location
ORiNOCO AP-8000 @ WD v1.0.0 SN-08UT41110039 v2.0.0(303290)
Exit from configure mode
Management Factory Reset
System Managment Config Restore
AP-8000 User Guide
141