Device Configuration - Proxim ORiNOCO AP-8000 User Manual

Using CLI to Manage the Access Point

Device Configuration

To configure the device parameters in Global Configuration Mode, type "?" to list the available commands.
>enable
#configure
(config)#?
commit System Management Config Commit
dev-configure Device Configuration
dev-management Device Management Configuration
dev-monitor Device Monitor Configuration
exit Exit from configure mode
reboot System Inventory Managment Reboot
To proceed with configuration, select each interface and enter the required parameters and their configurations.
Wireless Configuration
Properties Configuration
To configure Wireless Properties parameters in Interface 1, use the following commands.
NOTE: When "auto-channel-selection" is enabled, "current-operating-channel" cannot be configured.
Interface 1
(config)#dev-configure
(config-dev<config>)#interface
(config-dev<config>-if)#wireless
(config-dev<config>-if-wireless)#properties-tbl
(config-dev<config>-if-wireless-properties<tbl>)# radio 1 auto-channel-selection disable
(config-dev<config>-if-wireless-properties<tbl>)#radio 1 auto-rate-selection enable
(config-dev<config>-if-wireless-properties<tbl>)#radio 1 cellsize large
(config-dev<config>-if-wireless-properties<tbl>)#radio 1 current-channel-bandwidth 40
changes in current channel bandwidth reboot requires....
(config-dev<config>-if-wireless-properties<tbl>)# radio 1 current-operating-channel 36
(config-dev<config>-if-wireless-properties<tbl>)# radio 1 dtim 1
(config-dev<config>-if-wireless-properties<tbl>)# radio 1 operational-mode DOT11NG
changes in operational mode reboot requires....
(config-dev<config>-if-wireless-properties<tbl>)# radio 1 radio-status enable
(config-dev<config>-if-wireless-properties<tbl>)#radio 1 tpc 1
(config-dev<config>-if-wireless-properties<tbl>)# radio 1 ack-time-out 100
(config-dev<config>-if-wireless-properties<tbl>)# radio 1 vap-beacon-interval 100
(config-dev<config>-if-wireless-properties<tbl>)# radio 1 vap-rts-threshold 2346
Show command:
System Name# show configure interface wireless properties-table
// RUNNING-CONFIGURATION //
// Wireless Properties Table //
radio 1 {
radio-status: enable
operational-mode: DOT11NA
supported-operational-mode: DOT11NG,DOT11NA
current-channel-bandwidth: 40
supported-channel-bandwidth: 20,40
auto-channel-selection: disable
current-operating-channel: 36
supportedchannel: 36,44,52,60,100,108,116,124,132,149,157
auto-rate-selection: enable
supported-rate: 6,9,12,18,24,36,48,54
AP-8000 User Guide
117