Installation and Initialization
Optional Accessories
You can also use these optional accessories that Proxim recommends.
110-220V worldwide power adapter (1 Qty)
Range Extender Antenna (REA)
Gigabit Ethernet PoE
Hardware Installation
IMPORTANT:
Before installing and using this product, see Safety and Regulatory Compliance Guide available with
AP-8000 Answer ID 2813 at http://support.proxim.com.
Perform the following steps to install AP-8000:
•
Attach the Cables
–
Cabling with Power Adapter
–
Cabling with Gigabit Ethernet PoE
•
Using a Console Port
•
Install the Cable Security Cover (Optional)
•
Install the Antenna
•
Mount the Unit
•
Power on the Unit
Attach the Cables
NOTE: Proxim recommends to use CAT6 cable for the length of 100 m or CAT5e cable for lower length. Though
AP-8000 can work with CAT5 cable, there is a possibility that you may experience a drop in Ethernet speed from
1000BaseT to 100BaseT or Ethernet interface may show errors.
Cabling with Power Adapter
1. Plug the barrel of the power cable from the power supply into the power jack.
2. Connect one end of an CAT 6 Ethernet cable (not supplied) to the unit's Ethernet port. The other end of the cable
should not be connected to another device until installation is complete.
Cabling with Gigabit Ethernet PoE
1. To power the device using Gigabit Ethernet PoE, you must use Gigabit PoE injector (ordered separately). Connect
one end of a CAT6 Ethernet cable (not supplied) to the unit's Ethernet port. Connect the other end to the Data and
Power Out port of the PoE Injector.
AP-8000 User Guide
16