Password Management; Management Access Control; Reset To Factory - Proxim ORiNOCO AP-8000 User Manual

Access Point Features
Retrieve From Device Using TFTP - Features
• Server IP Address: This parameter represents the IP address for the TFTP server.
• File Name: This parameter represents the filename to upload or download to the TFTP server.
• File Type: This parameter represents the type of file being uploaded from the device.

Password Management

The Management Services feature allows the user to configure all the required passwords for the Access Point.
NOTE: The following special characters are not allowed while configuring the passwords.
- = \ " ' ? /
Services Features
HTTP Password: This parameter is used to set the HTTP login password. This password should be alphanumeric with
minimum of 8 and maximum of 32 characters.
HTTP: This parameter represents the TCP/IP port by which the HTTP server will be accessible.
HTTPS: This parameter is used to enable or disable the HTTPS access to the device from any host.
Telnet/SSH Password: This parameter is used to set the Telnet/SSH login password. This password should be
alphanumeric with minimum of 6 and maximum of 32 characters.
Telnet: This parameter is used to enable or disable the Telnet access to the device from any host.
SSH: This parameter is used to enable or disable the SSH access to the device from any host.
SNMP: This parameter allows to enable or disable the SNMP access.
SNMP Read Password: Provides Read access to AP using SNMP interface. The default password is "public". The
password should be alphanumeric with minimum of 6 and maximum of 32 characters.
SNMP Read/Write Password: Provides Read/Write access to AP using SNMP interface. The default password is
"public". The password should be alphanumeric with minimum of 6 and maximum of 32 characters.
Trap Host IP Address: This parameter represents the IP address of the management station that will receive SNMP
traps from the device.

Management Access Control

The Management Access Control feature allows the user to control an interface.
Management Access Control Feature Table Features:
• Access Table Status: This parameter is used to enable or disable the Access Control Table. By default it is disabled.
If this parameter is enabled, the device can be managed only with configured IP Address list.
• IP Address: This parameter represents the IPv4 IP Address for which the traffic need to be passed.

Reset to Factory

Reset to Factory feature allows the user to reset the device to its factory default state. This resets the network
configuration values, including the password, IP address, and subnet mask. The device will reboot automatically when
the user performs Reset to Factory operation. After reboot, the device is configured to its default values.
AP-8000 User Guide
52