Internal Storage Devices - HP Visualize J5000 Supplementary Manual

Field Replaceable Units (FRUs)
FRU Removal and Replacement

Internal Storage Devices

This section describes how to remove and replace the J5xxx and J7xxx workstation's
internal storage devices, including:
• Hard disk drives
• Optional CD ROM drive
• Optional DDS-3 tape drive
• Optional floppy disk drive
Hard Disk Drives
This subsection describes how to remove and replace hard disk drives.
NOTE You do not need to remove the workstation's front bezel, top or side panels to
access the hard disk drive bays. The bays are fully accessible when the right
door of the front panel's bezel is open.
NOTE The ability to hot plug the hard disk drive(s) requires MirrorDisk/UX
(Product Number B5403BA on HP-UX 10.20, or B2491BA on HP-UX 11.0
ACE 9911). If MirrorDisk/UX is installed on the workstation, you do not need
to power down the workstation nor unplug the workstation's power cord while
removing or replacing hard disk drives. Also see the "Hot Plug Disk Removal
Procedure" label on the bottom lip of the front panel for basic instructions.
Removing a Hard Disk Drive:
1. Open the right door of the bezel on the workstation's front panel.
CAUTION If you are hot-plugging a hard disk drive, the drive to be removed must be
inactive.
2. Push the plastic tab on the front of the hard disk to the right, which unlatches the
metal extractor lever.
Figure 4-6. Plastic Tab with Extractor Lever Closed
96
Plastic tab
Chapter 4