Figure 4-10; Figure 4-11 - HP Visualize J5000 Supplementary Manual

Field Replaceable Units (FRUs)
FRU Removal and Replacement
the next page.
Figure 4-10. Filler Panel in the CD ROM Drive Bracket
Filler panel
4. Insert the CD ROM drive into the bracket as shown in Figure 4-11. Secure the CD ROM
drive in the bracket using four T-10 Torx screws (two on each side) driven into the holes
indicated by the dashed lines in Figure 4-11.
Figure 4-11. Inserting the CD ROM Drive into the Bracket
Screw holes
for securing
CD ROM drive to
front panel
5. Slide the CD ROM drive bracket assembly halfway into the CD ROM drive bay.
6. From the top of the workstation, reach behind the CD ROM drive and connect the audio
cable, power cable, and ATAPI interface ribbon cable to the rear of the CD ROM drive.
Carefully fold in the cables to avoid damage during the next step.
7. From the front of the workstation, push the CD ROM drive bracket assembly to seat
flush against the front panel, taking care not to pinch the cables.
8. Insert and tighten the two T-15 Torx screws to secure the CD ROM drive to the front
panel of the workstation as shown in Figure 4-11 above.
100 Chapter 4