Figure 4-51 - HP Visualize J5000 Supplementary Manual

Figure 4-51. Screws for the I/O Board on the Rear Panel
T-15 Torx screws
8. Slide the I/O board to the left, which disengages the ten keyhole standoffs holding the
I/O board to the center wall of the chassis.
9. Pull the I/O board straight out until it clears the keyhole standoffs, and then lift it out
of the chassis.
Replacing the I/O Board
To replace the I/O board, do the following:
1. Remove the top panel and the right side panel from the workstation.
2. Perform the previous removal steps in reverse.
NOTE For correct installation, you must slide the I/O board to the rear of the
workstation chassis until the EMI (electromagnetic interference) fingers have
been compressed.
During installation, it is also very easy to miss some of the keyhole standoffs
that hold the I/O board to the center wall of the chassis. Therefore, be sure to
verify that all ten of the keyhole standoffs are engaged with the I/O board.
Chapter 4
Field Replaceable Units (FRUs)
FRU Removal and Replacement
135