Figure 4-25 - HP Visualize J5000 Supplementary Manual

Figure 4-25. Fan Cable Connector Tabs and Rear Panel Screws
T-15 Torx
screws on
rear panel
9. Remove the three T-15 Torx screws that secure the system board tray assembly to the
rear panel of the workstation, as shown in Figure 4-25 above.
CAUTION The J7xxx workstation's system board has four turbocoolers mounted
vertically to the left edge. Thus, the complete system board tray assembly will
be heavily weighted to one side. Approximate total weight for the system
board tray assembly is 12 lbs. Be prepared to handle the weight accordingly
in the next two steps.
10.Grasp the handle on the system board tray assembly and firmly slide the tray assembly
to the right, toward the front of the workstation. The sheet metal hooks on the
workstation's center wall will disengage from the holes on the system board tray
assembly.
11.Support the left side of the system board tray assembly and carefully pull the tray
outward.
NOTE Do not remove the system board from the tray.
Chapter 4
Field Replaceable Units (FRUs)
FRU Removal and Replacement
Connector tabs
for the 3 fan cables
113