Figure 4-59 - HP Visualize J5000 Supplementary Manual

4. Align the mounting bracket to snap in place over the mounting bracket's housing posts.
Slide the mounting bracket along the chassis floor until it snaps into place. Take care
not to pinch the cables to the inner chassis wall. Figure 4-59 shows the fan/speaker
mounting bracket correctly installed.
5. Connect the fan and speaker cables to the I/O board, as shown in Figure 4-59.
Figure 4-59. Fan/Speaker Mounting Bracket and Cables Installed
Fan/speaker
mounting bracket
6. Reinstall the power supply by following the replacement procedures in "Power Supply"
on page 128.
7. Reinstall the I/O cards by following the replacement procedures in "I/O Cards" on page
121.
8. Replace the PCI retainer clip.
9. Replace the top panel and the right side panel of the workstation.
Chapter 4
Field Replaceable Units (FRUs)
FRU Removal and Replacement
Fan cable
Speaker cable
141