HP Visualize J5000 Supplementary Manual page 104

Field Replaceable Units (FRUs)
FRU Removal and Replacement
Replacing a Hard Disk Drive:
NOTE If you are installing a new hard disk drive, the T-15 Torx screws for attaching
the drive in the bracket are stored on the bracket rails. Also see "Hard Disk
Drive Configuration" on page 36 for information about configuring a hard
disk drive for installation.
1. Open the right door of the bezel on the workstation's front panel.
2. Perform the previous removal procedure in reverse order.
NOTE To verify a good connection with the SCA hard disk interface (backplane
board) connector, press firmly on the outside corners of the bracket.
98 Chapter 4