HP Visualize J5000 Supplementary Manual page 43

CD ROM Drive (Optional) Configuration
The optional CD ROM drive connects to the ATAPI (IDE) interface in the CD ROM drive
bay backplane within the J5xxx and J7xxx workstations via a 40-pin ribbon cable, a 4-pin
audio cable, and a 4-pin power cable. No interface addressing is required for the CD ROM
drive.
However, as shown in Figure 2-1, the CD ROM drive should have a jumper set on the C
SEL (Cable Select) selection pins. (The CD ROM drive should ship from the factory already
jumpered for C SEL.)
Figure 2-1. CD ROM Drive Jumper Setting
Jumpered
for C SEL
Chapter 2
Field Replaceable Unit (FRU) Configurations
Configuration
37