HP Visualize J5000 Supplementary Manual page 105

CD ROM Drive (Optional)
This subsection describes how to remove and replace the optional CD ROM drive.
Removing a CD ROM Drive:
1. Remove the front panel bezel and the top panel from the workstation.
2. In the top, right front of the workstation above the CD ROM drive bay, remove the EMI
(electromagnetic interference) cover that is held in place by tabs. The EMI cover is
shown in Figure 4-9.
Figure 4-9. EMI Cover for the CD ROM Drive
EMI cover
3. Remove the two T-15 Torx screws securing the CD ROM drive bracket assembly to the
front panel of the workstation chassis and slide the bracket out half-way.
4. From the top of the workstation, reach behind the CD ROM drive and disconnect the
audio cable, power cable, and ATAPI interface ribbon cable from the rear of the CD
ROM drive.
5. Slide the CD ROM drive bracket assembly out of the chassis guide rails.
6. To remove the CD ROM drive from the bracket, remove the four T-10 Torx screws (two
on each side) securing the CD ROM drive to the bracket.
Replacing a CD ROM Drive:
NOTE See "CD ROM Drive (Optional) Configuration" on page 37 for information
about configuring a CD ROM drive for installation.
1. Remove the front panel bezel and the top panel from the workstation.
2. In the top, right front of the workstation above the CD ROM drive bay, remove the EMI
(electromagnetic interference) cover that is held in place by tabs. The EMI cover is
shown in Figure 4-9 above.
3. If you are installing a new CD ROM drive into the empty CD ROM drive bay:
a. Remove the two T-15 Torx screws securing the CD ROM drive bracket to the front
panel of the workstation.
b. Slide the CD ROM drive bracket out of the chassis guide rails.
c. Remove the filler panel from the CD ROM drive bracket as shown in Figure 4-10 on
Chapter 4
Field Replaceable Units (FRUs)
FRU Removal and Replacement
99