HP Visualize J5000 Supplementary Manual page 70

Troubleshooting
Identifying LCD-Indicated Conditions
Table 3-1. Chassis Codes for J5xxx and J7xxx Workstations
Ostat Code FRU
FLT 7207 DIMM
FLT 7208 DIMM
INI 721s DIMM
INI 722s DIMM
INI 723s DIMM
INI 724s DIMM
INI 725s DIMM
FLT 72As DIMM
FLT 72Cs DIMM
FLT 72Ds DIMM
INI 7300 SYS BD
TST 7301 SYS BD
WRN 7302 SYS BD
INI 7303 SYS BD
INI 7304 SYS BD
INI 7305 SYS BD
WRN 7306 SYS BD
INI 7307 SYS BD
FLT 7308 SYS BD
64
Message
DIMM table full
no DIMMs found
is DIMM s inst?
???? DIMM in s
128M DIMM in s
256M DIMM in s
512M DIMM in s
DIMM s checksum
DIMM s mismatch
DIMM s load err
mem config start
check mem config
mem confg changd
use confg change
build mem intrlv
save mem config
use alt mem conf
interleve memory
PDT is disabled
Description
The DIMM table is full--cannot add new
type.
SPD didn't find any memory DIMMs.
SPD is checking memory slot s.
SPD found a DIMM in slot s, but can't
determine its size. DIMM will not be used.
SPD found a 128MB DIMM in slot s.
SPD found a 256MB DIMM in slot s.
SPD found a 512MB DIMM in slot s.
DIMM in slot s failed SPD checksum and
will not be used.
DIMM in slot s didn't match the other in
pair. (J7xxx only--DIMMs must be in
matched pairs.)
Memory DIMMs are not in the proper
order. As a result, the system cannot
access DIMM s and has deallocated it.
Starting main memory configuration.
Checking for memory configuration
change since last boot.
Memory physical configuration changed
since last boot.
Memory physical configuration didn't use
saved configuration change. Use stored
configuration data.
Building memory configuration with all
DIMMs interleaved.
Saving memory configuration information
in non-volatile memory.
Memory will be configured from fixed
values, instead of detected DIMMs.
Generating the memory interleave.
Firmware detected bad memory pages,
but the Page Deallocation Table is
disabled.
Chapter 3