Figure 4-27; Figure 4-28 - HP Visualize J5000 Supplementary Manual

9. Secure the bus bars to the system board with either the four bus bar thumbscrews on
the J5xxx workstation, or the five bus bar thumbscrews on the J7xxx. Figure 4-27
shows these thumbscrews on the J5xxx workstation.
NOTE Failure to sufficiently tighten the bus bar thumbscrews will cause the power
supply to not activate.
Figure 4-27. Bus Bar Thumbscrews
10.Replace the bus bar shield by aligning the edge with the power supply edge while
inserting the hooks into the slots. Rock the bus bar shield into place by pressing down
towards the chassis floor. Figure 4-28 shows the bus bar shield correctly installed.
Figure 4-28. Bus Bar Shield Installed
Chapter 4
Field Replaceable Units (FRUs)
FRU Removal and Replacement
115