Tools Required; Exchange And Nonexchange Part Numbers - HP Visualize J5000 Supplementary Manual

Tools Required

Use the following tools to remove or replace FRUs:
• Light-duty flat blade screwdriver with 6-inch (150 mm) blade
• #1 Posi-Drive screwdriver
• T-10, T-15, and T-20 Torx drivers
• Needle-nosed pliers
• ESD equipment (see the "Electrostatic Discharge (ESD) Precautions" section later in
this chapter for detailed information)

Exchange and Nonexchange Part Numbers

In this chapter we refer to exchange and nonexchange part numbers. You must return
FRUs with exchange part numbers in exchange for replacement FRUs. Do not return
FRUs with nonexchange part numbers – you may discard them.
The following Tables 4-1 and 4-2 list the exchange part numbers for the J5xxx and the
J7xxx workstation, respectively.
Table 4-1. J5xxx Exchange Part Numbers
Part Number Description
A4978-69010 PCA J5000 system board tray assembly
A5991-69010 PCA J5600 system board tray assembly
A4978-69001 Power supply 830 W
A4978-69020 PCA - I/O board
A3862-69001 256 MB SDRAM DIMM
A3863-69001 512 MB SDRAM DIMM
A1658-69027 LVD hard disk drive 9 GB 10K RPM
A1658-69026 LVD hard disk drive 18 GB 10K RPM
C1537-69202 SCSI DDS-3 tape drive 12 GB
Chapter 4
Field Replaceable Units (FRUs)
Tools Required
83