HP Visualize J5000 Supplementary Manual page 98

Field Replaceable Units (FRUs)
FRU Removal and Replacement
Replacing the Front Bezel
To replace the front bezel, do the following:
1. Align the three metal bezel hooks into the three bezel hinge holes along the left edge of
the workstation's front panel.
Figure 4-3. Locations of the Bezel Hinge Holes
Bezel hinge holes
2. Press inward while rotating the front bezel counterclockwise.
3. Press firmly on the upper-right corner of the front bezel until it snaps into place.
4. Open the right-hand door of the front bezel and install the two T-15 Torx bezel-detach
screws on the top and bottom, right inside corners of the front bezel.
92 Chapter 4