HP Visualize J5000 Supplementary Manual page 113

5. Familiarize yourself with the order in which DIMMs must be inserted. This information
is on the "Memory Installation Sequence" label on the floor of the workstation's left side.
For more details, see the configuration section titled "Memory" on page 39 in Chapter 2.
NOTE The J7xxx workstation requires that DIMMs are installed in pairs of equal
memory size. In contrast, individual DIMMs of different memory sizes
(namely, 256 and 512 MB) may be installed in the J5xxx workstation.
6. Angle the left and right DIMM extractor handles on the empty DIMM slot outward.
7. Position the DIMM correctly to allow insertion into the DIMM slot.
8. Press firmly and evenly on the DIMM until it is fully seated in the slot. The extractor
handles will close inward as the DIMM is inserted.
9. If this is a J7xxx workstation, replace the front air divider and the four T-15 Torx
screws securing the front air divider.
10.Replace the workstation's top and left side panels.
11.To verify that the DIMM installation was successful, use the Boot Console Handler
procedure in "Displaying the Current Monitor Configuration" on page 162 in
Chapter 5.
12.If you replaced a faulty DIMM, use the pdt clear command in the Service Menu of
the Boot Console Handler. Answer y (yes) to the prompt Continue? (Y/N) >.
Chapter 4
Field Replaceable Units (FRUs)
FRU Removal and Replacement
107