10.2
Installing the System Indicator Board
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Attach the wrist strap.
Refer to Section 2.6, "Antistatic Precautions" on page 2-5.
2. Plug in the indicator board connector to the receptacle at the top of the fan tray
and replace the retaining clip.
3. Secure the board using the two screws.
4. Push the system indicator board housing on to the chassis until the plastic clips
engage.
5. Close the front doors.
6. Remove the wrist strap.
10-4
Sun Fire V1280 Service Manual • September 2002