Preparing And Installing The System; Installing The System - Sun Microsystems Sun StorEdge A1000 Installation, Operation And Service Manual

Preparing and Installing the System

You must perform the following tasks to prepare and install your Sun StorEdge
A1000 or D1000 system.
1. Set up your Sun StorEdge A1000 or D1000 with the mounting hardware, if any,
that came with your system.
2. Determine which SCSI target addresses are available on your host system.
Refer to the Solaris Handbook for SMCC Peripherals available on the Solaris AnswerBook
on-line documentation for information on how to determine which SCSI target IDs
are already in use.

Installing the System

1. Set the target addresses for your system (A1000 hardware RAID controller).
Controller Fault
Power Switch
Controller Active
IN/OUT
Blower Status 1 and 2
Note: x = 10Base-T Ethernet (reserved for factory or future use)
y = RS232C port(reserved for factory or future use)
Sun StorEdge A1000 Rear View
FIGURE 1-5
2. Set the option switch (D1000).
See or
FIGURE 2-7 FIGURE 2-8
Temperature Fault
SCSI ID Switch
Controller Power
x
IN/OUT
Power
Supply
Status
for split box configurations.
Battery Fault
Battery Charge
Battery
Blower Status 3 and 4
y
Power
Supply
Status
Chapter 1 Getting Started 5