Configuring VLAN-VPN
2
Basic VLAN-VPN Configuration
To complete the basic VLAN-VPN configuration, follow these steps:
1) Configure 802.1Q VLAN.
2) Enable VLAN-VPN globally and configure up-link ports
Configuration Guidelines
The TPID preset by the switch is 0x8100. If devices in the ISP network do not support the
value, you should change it to ensure VLAN-VPN packets sent to the ISP network can be
recognized and forwarded by devices of other manufacturers.
2.1
Using the GUI
2.1.1 Configuring 802.1Q VLAN
Before configuring VLAN-VPN, set the link type of ports according to network requirements,
and create an 802.1Q VLAN as ISP network VLAN and an 802.1Q VLAN as customer
network VLAN. Add ports connecting the customer network to the customer network
VLAN; add ports connecting the customer network and ports connecting the ISP network
to the ISP network VLAN. For details, refer to
2.1.2 Enabling VLAN-VPN Globally and Configuring Up-link Ports
Choose the menu VLAN > VLAN-VPN > VPN Config to load the following page.
Figure 2-1 Global VPN Configuration
Basic VLAN-VPN Configuration
Configuring 802.1Q
VLAN.
Configuration Guide
235