Ip Pim Bsr-Candidate Interface - TP-Link T2700G-28TQ Cli Reference Manual

T2700G-28TQ JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
Syntax
ip pim spt-threshold infinity
no ip pim spt-threshold infinity
Command Mode
Global Configuration Mode
Example
Configure all the sources never switch to the source tree:
T2700G-28TQ(config)# ip pim spt-threshold infinity

ip pim bsr-candidate interface

Description
The ip pim bsr-candidate command is used to configure the candidate BSR on
specified interface. To disable the candidate BSR, please use no ip pim
bsr-candidate command.
Syntax
ip pim bsr-candidate interface { { fastEthernet | gigabitEthernet |
ten-gigabitEthernet } port | loopback id | vlan vlan-id } [ hash-mask-length
mask-len ] [ priority pri ]
no ip pim bsr-candidate
Parameter
fastEthernet | gigabitEthernet | ten-gigabitEthernet —— The port type of the
interface.
port —— The port number.
id —— The interface loopback ID.
vlan-id —— The interface VLAN ID.
mask-len —— Hash function mask length, ranging from 0 to 32.
pri —— The priority of the BSR, ranging from 0 to 255.
Command Mode
Global Configuration Mode
Example
Configure the candidate BSR on interface VLAN 2:
334