Receiving An Ip Address From A Dhcp Server - TP-Link TL-SG3109 Installation Manual

TL-SG3109/TL-SL3428/TL-SL3452
accounting (AAA) mechanism, and includes the following topics:

Receiving an IP Address from a DHCP Server


Receiving an IP Address from a BOOTP Server

Security Management and Password Configuration

When configuring or receiving IP addresses through DHCP and BOOTP, the
configuration received from these servers includes the IP address, and may
include a subnet mask and default gateway.
4.5.1 Receiving an IP Address from a DHCP Server
When using the DHCP protocol to retrieve an IP address, the device acts as
a DHCP client. To receive an IP address from a DHCP server, perform the
following steps:
1. Select and connect any port to a DHCP server or to a subnet that has a
DHCP server on it, in order to retrieve the IP address.
2. Enter the following commands to use the selected port for receiving the IP
address. In the following example, the commands are based on the port
type used for configuration.
console# configure
console(config)# interface vlan 1
console(config-if)# ip address dhcp hostname admin-host
console(config-if)# exit
console(config)#
3. To verify the IP address, enter the show ip interface command at the
system prompt as shown in the following example.
Gigabit Managed Switch Family Installation Guide
34