Dhcp Server - TP-Link JetStream T2700G-28TQ User Manual

Configuration Procedure

Configure Switch A

Steps Operation
1 Add interface
VLAN 10
2 Add interface
VLAN 20
3 Add static route
entry
Configure Switch B

Steps Operation
1 Add interface
VLAN 20
2 Add interface
VLAN 30
3 Add static route
entry
Configure the PCs

Configure the default gateway of PC1 as 192.168.0.1 and the default gateway of PC2 as
192.168.2.1.

10.4 DHCP Server

DHCP module is used to configure the DHCP functions of the switch, including two submenus,
DHCP Server and DHCP Relay.
Overview

DHCP (Dynamic Host Configuration Protocol) is a network configuration protocol for hosts on
TCP/IP networks, and it provides a framework for distributing configuration information to hosts.
DHCP is adding the capability of automatic allocation of reusable network addresses and
Note
Required. On page Routing→Interface→Interface Config, add
interface VLAN 10 with the mode as static, the IP address as
192.168.0.1, the mask as 255.255.255.0 and the interface name as
VLAN10.
Required. On page Routing→Interface→Interface Config, add
interface VLAN 20 with the mode as static, the IP address as
192.168.1.1, the mask as 255.255.255.0 and the interface name as
VLAN20.
Required. On page Routing→Static Routing→Static Routing
Config, add a static route entry with the destination as 192.168.2.0,
the subnet mask as 255.255.255.0 and the next hop as
192.168.1.2.
Note
Required. On page Routing→Interface→Interface Config, add
interface VLAN 20 with the mode as static, the IP address as
192.168.1.2, the mask as 255.255.255.0 and the interface name as
VLAN20.
Required. On page Routing→Interface→Interface Config, add
interface VLAN 30 with the mode as static, the IP address as
192.168.2.1, the mask as 255.255.255.0 and the interface name as
VLAN30.
Required. On page Routing→Static Routing→Static Routing
Config, add a static route entry with the destination as 192.168.0.0,
the subnet mask as 255.255.255.0 and the next hop as
192.168.1.1.
148