Server Configuration - Rice Lake REVOLUTION 682 Synergy Plus Technical Manual

682 Synergy Plus
9.2.2

Server Configuration

The wireless module is configured to be a server by default, with the ability to accept the connection of a client to it.
• A Server is waiting to Accept a connection from a Client.
• A Client is looking to Connect to a remote Server (host).
NOTE: Even though a device can be set up for both, typically it is only set up as one or the other.
The following procedure shows where the wireless module's server settings are found using the Web Manager.
NOTE: Making changes to the Tunnel 1 Accept Configuration settings may impact the wireless module's connection to the
location's network, established in Wi-Fi Setup
1. Refer to Steps 1-6
2. Click Tunnel in the left navigation panel.
3. Click Accept towards the top of the Tunnel 1 Status page.
4. Change the Mode and Local Port settings if needed.
5. Click Submit at the bottom of the page to apply and save the settings. A message displays at the top of the page to
confirm the changes have been saved permanently.
68 Visit our website
(Section 9.2.1 on page
in Section 9.2.1 on page 64
www.RiceLake.com
64).
to sign in to the Web Manager.