Operation / Printing; Printer Settings; Maintenance; Changing The Roll Of Paper (Thermal Paper) - wtw inoLab Multi 9310 IDS Operating Manual

Printer (only Multi 9310P IDS)
94

13.2 Operation / printing

Data are only output to the printer if the following requirements are met
 Data are transmitted manually or automatically (see section 12 T
, page 90)
TING DATA
 The printer is switched on (LED illuminated)
 There is no USB connection.

13.3 Printer settings

To open the Storage & config menu, press the
sured value display. After completing the settings, switch to the measured
<M>
value display with
Default settings are printed in bold.
Menu item
System / Printer /
Font size
System / Printer /
Print test page

13.4 Maintenance

13.4.1 Changing the roll of paper (thermal paper)

1. Pull the lever (3) until the lid (4) of the paper compartment opens.
2. If necessary, remove any remains of the old roll of paper.
3. Insert the new roll of paper. The start of the paper should poke out of
the paper compartment.
4. Close the lid (4) of the paper compartment so that it clicks into place.
5. If necessary, move the printer paper forward with
.
Possible set- Explanation
ting
Select the font size for the printer
12x20
8x16
A print sample (font of the printer) to
7x16
view the available font sizes can be
output with
- The printer prints the meter informa-
tion from the menu System / Ser-
vice information.
The current printer settings are
used for the print.
®
inoLab Multi 9310 IDS
RANSMIT
<F1__>
[Menü] key in the mea-
<ON/OFF >
_ .
<FEED>
.
ba75937e10
-
08/2021