Table of Contents
Advertisement
®
inoLab
Multi 9310 IDS
ba75937e10
08/2021
17.2 Firmware-Update for IDS Sensors
With the "Firmware Update" program and a PC you can update the firmware of
an IDS sensor to the newest version.
You can find available firmware update files for your IDS sensor on the Internet.
For updating, use cables to connect the IDS sensor to the Multi 9310 IDS, and
the Multi 9310 IDS to a PC.
For the update via the USB-B interface, the following is required:
a free USB interface (virtual COM port) on the PC
the driver for the USB interface (on the enclosed CD-ROM)
the USB cable (included in the scope of delivery of the Multi 9310 IDS).
1.
Install the downloaded firmware update on a PC.
An update folder is created in the Windows start menu.
If an update folder already exists for the sensor (or sensor type), the
new data are displayed there.
2.
In the windows start menu, open the update folder and start the firm-
ware update program for the IDS sensor
3.
Connect the IDS sensor to the Multi 9310 IDS meter.
4.
Using the USB interface cable, connect the Multi 9310 IDS to a USB
interface (virtual COM port) of the PC.
5.
Switch on the Multi 9310 IDS.
6.
In the firmware update program, start the update process with OK.
7.
Follow the instructions of the firmware update program.
During the programming process, a corresponding message and a
progress bar (in %) are displayed.
The programming process takes up to 5 minutes. A terminatory mes-
sage is displayed after a successful programming process. The firm-
ware update is completed.
8.
Disconnect the Multi 9310 IDS from the PC.
Meter and sensor are ready for operation again.
After switching the meter off and on you can check whether the sensor has
taken over the new software version (see Y
VERSION IS IN THE METER OR
OU WANT TO KNOW WHICH SOFTWARE
IDS
,
102).
SENSOR
PAGE
Firmware update
107
Advertisement
Table of Contents
