Operation / Printing; Printer Settings; Maintenance; Changing The Roll Of Paper (Thermal Paper) - wtw pH/ION 7320P Operating Manual

pH/ION 7320
ba75935e04 12/2017
4.2

Operation / printing

Data are only output to the printer if the following requirements are met
 Data are transmitted manually or automatically (see section 11.1 O
FOR DATA TRANSMISSION
 The printer is switched on (LED illuminated)
 There is no USB connection.
4.3

Printer settings

To open the Storage & config menu, press the <ENTER_> key in the measured
value display. After completing the settings, switch to the measured value dis-
play with <M>.
Default settings are printed in bold.
Menu item
System / Printer /
Font size
System /
Printer /
Print test page
4.4

Maintenance

4.4.1 Changing the roll of paper (thermal paper)

1. Pull the lever (3) until the lid (4) of the paper compartment opens.
2. If necessary, remove any remains of the old roll of paper.
3. Insert the new roll of paper. The start of the paper should poke out of the
paper compartment.
4. Close the lid (4) of the paper compartment so that it clicks into place.
5. If necessary, move the printer paper forward with <FEED>.
, page 84)
Possible set- Description
ting
12x20 Select the font size for the printer
8x16
7x16 A print sample (font of the printer) to
view the available font sizes can be
output with <ON/OFF_>.
- The printer prints the meter informa-
tion from the menu, System / Ser-
vice information.
The current printer settings are
used for the printout.
Printer (only pH/ION 7320 P)
PTIONS
15