wtw inoLab Multi 9310 IDS Operating Manual page 82

Settings
ORP
Dissolved oxygen
Conductivity
82
The following settings for ORP measurements are reset to the default settings
with the Reset function:
Setting
mV resolution
The sensor settings are reset under the Reset menu item in the menu for cali-
bration and measurement settings. To open the settings, display the required
measured parameter in the measured value display and press the
key.
The following settings for D.O. measurements are reset to the default settings
with the Reset function:
Setting
Calibration interval
Check interval
Measured parameter
Relative slope (S )
Rel
Salinity (value)
Salinity (function)
The sensor settings are reset under the Reset menu item in the menu for cali-
bration and measurement settings. To open the settings, display the required
measured parameter in the measured value display and press the
key.
The following settings for conductivity measurements are reset to the default
settings with the Reset function:
Setting
Calibration interval
Measured parameter
Cell constant (c)
Temperature compensation
Reference temperature
Temperature coefficient (TC) of
the linear temperature compensa-
tion
TDS multiplier
The sensor settings are reset under the Reset menu item in the menu for cali-
bration and measurement settings. To open the settings, display the required
inoLab
Default settings
0.1
Default settings
180 d
60 d
D.O. concentration (mg/l)
1.00
0.0
off
Default settings
150 d
ϰ
Depending on the connected measur-
ing cell:
-1
0.475 cm (calibrated)
-1
0.475 cm (set)
-1
0.100 cm
nLF
25 °C
2.000 %/K
1.00
®
Multi 9310 IDS
<ENTER>
<ENTER>
ba75937e10 08/2021