Table of Contents
Advertisement
Operation
Setting the date,
time and date format
26
Identification of stored measured values.
Therefore, check the time at regular intervals.
The date and time are reset to default after a fall of the supply volt-
age (empty batteries).
The date format can be switched from the display of day, month, year
(dd.mm.yy) to the display of month, day, year (mm/dd/yy or mm.dd.yy).
1.
In the measured value display:
Open the Storage & config menu with
The instrument is in the setting mode.
2.
Select and confirm the System / Clock function menu with
<ENTER>
.
The setting menu for the date and time opens up.
Clock function
Date format:
Date:
Time:
03.04.2013
Back
08:00
3.
Select and confirm the Time menu with
The hours are highlighted.
4.
Change and confirm the setting with
The minutes are highlighted.
5.
Change and confirm the setting with
The seconds are highlighted.
6.
Change and confirm the setting with
The time is set.
7.
If necessary, set the Date and Date format. The setting is made similarly
to that of the time.
8.
To make further settings, switch to the next higher menu level with
or
Switch to the measured value display with
The instrument is in the measuring mode.
<ENTER__>
dd.mm.yy
03.04.2013
14:53:40
<
><
<
><
<
><
<
><
<M>
®
inoLab
Multi 9310 IDS
.
<
><
>
>
<ENTER>
and
.
>
<ENTER>
and
.
>
<ENTER>
and
.
>
<ENTER>
and
.
<F1>
.
ba75937e10
08/2021
and
.
Advertisement
Table of Contents
