Operation / Printing; Printer Settings; Maintenance; Changing The Roll Of Paper - wtw Multi 9310 Operating Manual

Printer (only Multi 9310P)
84

12.2 Operation / printing

Data are only output to the printer if the following conditions are met
Data are transmitted manually or automatically (see section 11.4 O
FOR DATA TRANSMISSION TO A
the printer is switched on (LED illuminated)
there is no USB connection.

12.3 Printer settings

To open the Storage & config menu, press the <F1__>[Menü] key in the mea-
sured value display. After completing the settings, switch to the measured
value display with <M>.
Default settings are printed in bold.
Menu item
System / Printer /
Font size
System / Printer /
Print test page

12.4 Maintenance

12.4.1 Changing the roll of paper

1. Pull the lever (3) until the lid (4) of the paper compartment opens.
2. If necessary, remove any remains of the old roll of paper.
3. Insert the new roll of paper. The start of the paper should poke out of
the paper compartment.
4. Close the lid (4) of the paper compartment so that it clicks into place.
5. If necessary, move the printer paper forward with <ON/FEED>.
PC, page 82)
Possible set- Description
ting
12x20 Select the font size for the printer
8x16
7x16 A print sample (character set of the
printer) to view the available font
sizes can be printed with <OFF_>.
- The printer prints the meter informa-
tion from the System / Service infor-
mation menu.
The current printer settings are
used for the printout.
Multi 9310
PTIONS
ba75937e03 12/2011