Table of Contents
Advertisement
ETAS
To set the default behavior for signal-to-axis assignment
To reduce the configuration effort, you can define the default behavior for sig-
nal-to-axis assignments by using the Properties window.
To delete axes
5.2.6
Basic Navigation
To navigate within the oscilloscope, you can perform the following actions:
"To navigate from axis to strip to signal list" below
l
"To navigate between the strips" on the next page
l
"To navigate between the axes" on the next page
l
"To navigate between the signals in the signal list" on the next page
l
"To navigate to the time slider" on the next page
l
For more information about the use of the keyboard, see "Operating MDA via
Keyboard" on page 14.
To navigate from axis to strip to signal list
To quickly navigate horizontally within the oscilloscope use the T
backwards press S
MDA V8.6 – User Guide
1. Click the tab Instrument in the Properties window.
2. Select one of the following entries from the Signals Distribution
menu:
Per unit one axis
One common axis
Individual axes
The setting is applied when adding signals with the I
in the Configuration Manager. It is used for newly added signals
from the Variable Explorer or from other instruments, given the
signal can be assigned to a shared axis.
In case a signal is added by drag and drop, the selection wheel
appears. For more information, see "To assign signals using the
selection wheel" on page 90.
Note that an axis can be shared only for matching data types and
the same data representation. "No-Match" signals get an own
axis, as the original unit is not known.
If the signals are dropped from another oscilloscope, the axis
assignment from the source oscilloscope remains unchanged.
1. Right-click a value axis.
2. Click Delete Axis.
The axis is deleted and the signals are removed from the view.
+T
.
HIFT
AB
5 Instruments
key or
NSERT
key and
AB
94
Advertisement
Table of Contents
